Hello all
I finished the CFX install about two weeks ago and everything worked great. I started to use different profiles and the board started to act strange. It would not start up or would start up on its own. I made sure battery was charged and reinstalled firmware and fresh sd package. The board boots up ok but does not react to activation or auxilliary buttons. I did a voltage check on the board related to the manual and some readings are definitely out. Main switch is under 1vdc and aux. switch I also below 3.3vdc. Just to the side of the motion sensor are what looks like two resistors. The one on the left should read 14vdc but I am only getting 8.86vdc. Would someone please shed some light on this problem on how to get my board working again.
Thanks