I built a neopoxel saber and programmed it as needed it was the first time doing this style the problem i have is that the
saber fires up and works but when i choose a bright color or I tap it and it gives flash on clash it turns off, and I have
to put in the kill key and then pull it out so it can again start up, it will stay on when i push the button and hum while turned on but
the moment i tap it it goes off if I choose a bright color it goes off and so on etc. i have a 7.4 battery in it and a charge
port I have noticed that if it sits alone for a while or the battery is low it will work almost decently what do I needed to
to fix it, I am using a crystal focus 10 and it should be able to handle 7.4 volts any good ideas or solution is appreciated.