I am not sure if the two are related, but I just finished my first wire job, and am close, but not all the way there.
It is an NBv3 and when it boots, it gives a beep and a mini reboot sound repeatedly. I haven't touched the SD card at all, so I am not sure it would be the files, but the manual seems to suggest so.
Additionally, the main LED doesn't light up at all. I am not sure if these are related, or something else, but I know it is getting power as the CC 5mm lights up just fine, as does the speaker of course. I tend to think it might be the switch, but I am not sure how that could be. Could the sound card issues cause the blade not to light up?
In case it helps, here is my wiring diagram:
wiring.jpg
And here are some shots of the LED and switch. The joints looked OK to me, but I am by no means an expert.
LED_wire.jpg LED_wire2.jpg switch.jpg board.jpg
Bookmarks