Hey guys! I will order the parts for my first build very soon, so in the meantime i was planning my second saber, which is featuring a PRIZM
I am still planning a little so advice would be appreciated as always. I aswell may or may not make a build-log for this
So now to the parts I want to use:
- HILT:
- 8 inch double female extension
- Pommel style 3
- Blade holder style 18
- Box 14
- MISC:
- 8-32 thumb screw for blade retention
- diamond knurling 3.5 inches
- Drill & Tap for the blade retention screw
- 1" Thin walled clear PolyC 34" long
- Clear 1" thin walled blade tip
- quad film
- holes for box 14
- powder coating flat black for bh 18
- ELECTRONICS:
- PRIZM V4
- recharge port
- R.I.C.E. port
- Tri-Cree RGrB
- thermal pads
- LED lense
- 2x 16mm AV switch -illuminated in red and orange
- 28mm Bass speaker
- Resistor - 1x 1 Ohm for red - 2x 0.47 ohm for blue and green
- Dyna-Ohm x2
- CHASSIS:
- acrylic disks for PC and 18650 battery
- aluminium spacers: working on it
- Chamber:
maybe if I have space
Thank you for helping/suggestions
Cheers,
Greg
MySaber2.jpgMySaber2internal.jpg
Bookmarks