-
Roque Sound Font, clicking noise?
So, I purchased the Roque font.
Itīs awesome to say the least.
I did what I always do, since Iīm not packing a CF.
Selected the swings, clashes, power on/off that I wanted.
The volume was quite low on this font, so I decided to up the volume in Audacity, as I always do with fonts.
Now after a clash or swing, thereīs a clicking noise when returning to the hum.
I tried everything I could think of, but no luck.
If I just load the original volume on the font, it sounds fine.
Any ideas?
Btw, the board is a Nano Biscotte V3 with 28mm bass speaker from tcss.
-
Sounds like the font is clipping when you run it through Audacity. Watch your peaks.
-
Also when you save, clear the metadata.
-
Thanks guys, will try again.
Good input!
-
Whenever you change the volume of a sound file you risk altering a number of things. Perhaps the zero crossings at the beginning and end of each file get altered. I would check those too.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks