diagram.jpg
can you guys tell me how this looks?
diagram.jpg
can you guys tell me how this looks?
Checks out, just like they wrote it up in the manual.
so its okay to have 2 wires conected to 1 pad? cause in the manule diagram it looks like a wire branches of from another wire? likethey just attached a wire 2 a middle of another wire wich looks more difficult and impractical.
It's typically easier to attach a single wire to a pad, and do a splice further down. Both ways are correct, but it can be tricky for a novice to connect two wires to a single pad at the same time.
If you twist the ends of the two wires together and pretin them as a single unit, it isn't so hard to connect them to the pad.
We all have to start somewhere. The journey is all the more impressive by our humble beginnings.
http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!
okay thank you
Can also try to solder the second wire on the underside of the board. Should be a pad there, too.
Bookmarks