Hello, guys
I'm still a newbie, but trying to improve and gain knowledge with each build.
This was my first build with the spark soundboard. The wiring seemed pretty straight forward and I didn't run into too much difficulty.
(Thanks to what I have been taught by you guys here at the forums)
This was also my first attempt to build a Hilt sleeve and Emitter shield. I found out very quickly that the Dremel wheel can grab and take off very quickly with Aluminum. I had to slow down and be very patient.
After lots of filing, sanding and polishing I went from jagged to something presentable.
I had a lot of fun with this build.. and after attempting some custom components, I gained even more respect(if possible) for the talent on these boards. I can only imagine what it takes to design and create some of these high end sabers.
Anyhoo, here's is the Vengeance. Input and or advice appreciated.
video below
Bookmarks