The exterior of my second build is mostly done. Not sure if the weathering is too much or not -- I might tone it down before I clear it with a satin finish, but it is pretty close.

Everything is from the shop, with two custom pieces. Tim did an amazing job on the bezel towards the pomel (will be LED lights) and a custom internal spacer to give another layer (it spaces out a female 3" and a double male).
Everything else is done by hand (so please pardon the lack of precision). Don't even have a drill press yet.
The CC fins are brass washers.
The switch button and most of the outside was made from shroud material.
The D-ring holder (I left the D-ring out for now as it is too big, but I wanted to have it there to use when I needed it to) has a cover I made from some ABS plastic pieces so it looks purposeful.














The chassis is undergoing finishing, but I will have that soon (time permitting).

I need to wait on the electronics a bit, but that is probably a good thing as the neopixel stuff the store is working on looks like it will be awesome.