Jediseth

Braid or twist several wires together to avoid the spaghetti. As for the chassis, need to see what you're currently working with.

Ridire, I use TCS WOW speakers all the time. It should be fine in your Spkr4 holder, its the same relative size as the Veco Bass 28mm sold also...

I would be worried. But its pretty easy to test. Just put the hilt in water for a period of time, take it out, dry the exterior, crack the thread and...

I NEVER REUSE the chineseum wires that come on the neopixels. It is absolutely dreadful. 22ga feeds (+ and-) 26 ga for data. I have hot glued the...

Glad you found it.

Lack of response is due to the forums going pretty quite overall in the last 2 years or so. I haven’t done a setup like this so haven’t really...

Simple. There are copper traces running through both sides of your switch holes. Now remember, switches both share a common ground, but the switch...

A chassis’ purpose is to hold your components securely to prevent damage, prevent shorts, ensure proper operation, facilitate good wire management,...

That would be better. People have made pvc chassis in the past. Some very reputable smiths at that.

Not advisable at all. Use a proper chassis solution. The store sells everything you need. You don’t necessarily have to use a 3D printed solution.

Are you using an appropriate battery? Need one with a 15A cutoff. I'd be suspicious of a short in the strips or how they are wired with the...

If the strips worked fine before you put them back to back, check for shorts between the strips. When they are back to back, you can have many areas...

Sorry you mentioned the specs In the first post. The new speaker you ordered has a higher power rating so you are ok there. It has a lower resistance...

Did it come with a manual or specs that could tell you what speaker can be used? Or, does the old speaker have rating markings on it? I know...

Well, what is outside diameter of your controllers? Once you have that, or can modify it to fit MHS, then we can maybe help guide you about how you...

Doh! I was looking in thick-walled section and not in "neopixel" supplies. I guess you already have it. Maybe just list in in both places? Here...

Well, this one, but hollowed out like the ones available for the 1" thin-walled blades: ...

So much greatness in the Outer hilt and inner core. I am always amazed with your work, absolutely awesome. Tom

Absolute Starkiller mastery SA2CC!!!! This saber ROCKS. The maker should be very proud. Tom

Yes, Korbanth/Parks/TCSS Crossguard 2.0

Thanks a lot guys. :mrgreen: