Page 2 of 2 FirstFirst 1 2
Results 11 to 14 of 14

Thread: Could someone tell if I'm using the wrong parts, or just wiring it wrong?

  1. #11


    The question here about your LED, not full circuit (which are in series, not parallel). There are 3 LEDs, how are they wired?

  2. #12


    My LED is a Tri-Cree with ×1 White & ×2 Blue diodes. I have the Negative soldered to one of the Minus soldering points, & the Positive soldered to the Plus soldering point directly opposite, since all the diagrams I saw only used a single Pos & Neg connection for Tri-LED configurations. Was I supposed to do a Pos & Neg connection for each individual diode?

  3. #13


    Pictures would be a huge help here.
    All n00bs READ these first (PLEASE)!!!:
    1. Forum Guidelines
    2. FJK’s “Down and Dirty” guide to Ohm’s Law

    "Yeah, yeah, I've heard it all before... you want blindingly bright, super loud, running 1138 blinkies off of the cheapest sound card you can find AND you want all of it to run on a battery the size of a dime, and run for a very, VERY long time. That one cracks me up every time..."
    My email:

  4. #14


    Temporary switch means momentary? I believe your setup requires a latching switch.

Tags for this Thread


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts