I started this saber about 5 years ago. It's TCSS parts (a long choke and two short extensions for the body) with part of the TCSS recharge port disks and a 3d printed chassis to hold the speaker and an NB2 (what was new when I purchased the original parts.) I etched the shroud this week. The entire thing is weathered with acrylic paints in black and some rusty browns and there is a little bit of green on the shroud, too.

49731831128_ab268e4b74_z.jpg

49731831088_b091ffe38c_z.jpg

49732377961_ecc944b777_z.jpg

49732378006_5a7b27fb15_z.jpg

49732378026_2e3738433b_z.jpg

49732700037_f8209c7abf_z.jpg