Ok, so I built a neopixel lightsaber, wired it up outside the hilt and it worked fine, but when I put it inside the hilt the LED's don't light up. I took it out and checked all the connectors and wires, they're fine, nothing is shorting so I'm stumped as to what the issue could be. Any idea's as to what the problem is? The wires did twist a fair bit when I tried to get it in the hilt. I'm using a NBV4 assembly, momentary switch, a 18650 panasonic battery (protected), the css neopixel adaptors and two WS2812B strips. The soundboard still works without the LED's plugged in so the board is fine to my knowledge. Any advice would be much appreciated