Hoping someone has ran into this issue and can shed some light this noob's direction.
This is my third build and here is my setup:
R/G/B Tri Cree
3.7v li-ion
2w 8ohm premium speaker
Prizm v4
16mm momentary A/V act. switch
12mm momentary A/V aux switch
dynaohm resistor on positive leg of aux. switch LED
Everything is working except the led ring on the aux switch. Thinking I may have mixed up the wiring somewhere. I've tested the switch with another battery pack directly and it lights up fine. all solder joints are nice and shiny.
I have the act. switch wired to the act. pad and ground pad, and the aux switch to aux. pad and grounded on top of the act. switch lead
Then for the aux. switch LED, I have the positive dynaohm lead on the "1" pad for accent led and the negative LED switch lead on the Accent LED ground pad
Ive also tried soldering the aux. switch LED positive dynaohm lead to the positive battery pad instead of the LED accent pad thinking it would provide direct power that way but it doesn't light up.
There's probably a simple solution im overlooking. Any guidance would be appreciated
Bookmarks