-
Jedi Initiate
Activation Box as Switch?
I’m thinking about doing something new for my (ongoing) Kanan Jarrus saber build. Here’s what I’m thinking: rather than just attaching the switch box to the hilt, make the whole box slide up (or down) slightly to function as a switch. A spring, or perhaps rare earth magnets, would snap it back in place after activation. It would push on one of those switches that has a long activation arm, which I could cut or shape as needed. (See photo.) I think I could keep the movement to 1cm. That would eventually cause wear on the saber, but that’s no big deal for me.
Has anybody tried anything like that?
FBFACB4D-DA1D-4343-B10B-15070DB0099E.jpg
Last edited by hapki; 09-16-2018 at 06:57 AM.
-
I haven't done this before, but I like this idea. I think if you put a magnet pair at either end it could lock in place well enough. For my tastes the wear would only be a bonus.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks