Low Profile Kill Key

[Darth Nurse]

Looking to use the chassis mounted recharge port and it looks like I will need a kill key with a very low profile, but still able to be grabbed and removed.

Any ideas or examples?

[jbkuma]

Do you want it to be decorative at all, or just a plug to have in their when not in use?
You could epoxy a thumb tack head on. I'm using a 6-32 thumb screw which is fairly low profile, one could sand it down to make it even more so. Before that I was using the head of a machine screw.

[Darth Nurse]

It will be hidden inside when not in use, so not really decorative.

[minorhero]

Make a kill key using a ground down rare earth magnet. Then use another rare earth magnet on a stick to remove it. That way you can make the head of the kill key very shallow and not need to worry about grip.

Mind you I have never done this, just brainstorming.

[rlobrecht]

Do you need your kill key to be low profile? If the recharge port is inside the hilt with no exposure to the outside, you must plan to reveal the port to charge your battery. Couldn't you do the same to insert a full size kill key? Its just another option to think of.

[Darth Nurse]

Do you need your kill key to be low profile? If the recharge port is inside the hilt with no exposure to the outside, you must plan to reveal the port to charge your battery. Couldn't you do the same to insert a full size kill key? Its just another option to think of.

That would mean storing it with the bottom half of the hilt off.