Hi all.
I could subtitle this " My vinyl cutter hates me now" lol.
So I decided to make a Light side saber, and depart from my usual weathering and such. But not from the etching, as you can see. Every single part, minus the choke, has some etching on it. I only polished and painted the choke, it got off easy.

I used the base pattern from my saber Havok's Ember, and modified it for this build and these parts. After etching I went over the whole saber with Mother's alu polish. I wanted to get out of my comfort zone and build a shiny saber.
Inside it's got:
PRIZM 4.0
3.7v 3600 mah
Tri-cree RGrB
JQ sabers red ring switch, wired to accent pad 1, for customization
black aux switch
recharge port and kill key
a 3d printed PRIZM chassis from GOTH3Designs
bass speaker

Here goes. Like it? Hate it? Please let me know, and thanks for looking.
-Darkmatter73