Originally Posted by
mrlemon
Thanks, Darkmatter73!
We only want the LED in the AV switch to be on when the blade is on.
But we're not clear on how to interpret the parameters in the manual.
The 3.3V pad (NB4 Manual, p.15) is recommended only if "the saber is equipped with a main power switch (more likely a recharge port with a killkey) ...."
My student plans on using a 16mm AV switch and a recharge port, so I assume the AV switch satisfies the role of a main power switch.
Is that a correct assumption?
Yes.
He also plans to use an internal recharge port (using the acrylic chassis disk for a recharge port), but to leave out the killkey to prevent opening the pommel every time he wants to turn on the saber.
Would that choice satisfy using a "...recharge port with a killkey?"
Yes, but the battery will eventually drain.
I guess I could also reconfigure the deep parameter in the config file, too, to save power and shorten the time to deep sleep.
What's your opinion on which pad to use?
For the scenario you’re describing, you would want to wire the switch’s LED in parallel with the main LED. This way it goes on when the main LED is on.
Thanks for the help, and best regards!
-Mike
Bookmarks