Originally Posted by
Tom Tilmon
I have installed a lot of NBIVs, but have never bridged pos and negative. I have burnt some other boards, not sold at TCSS though. its part of the learning process. Don't give up on it yet, clean up all the solder, hook a speaker to it, reformat and fill the SD card, and just run 3.7 volts to it with a speaker and see if you get a boot sound. If you do, hook up a switch, and see if features work. Basically mock it up outside your chassis.
Then hook all your other stuff up. Try to shorten the amount you strip from your wires, you are stripping too much insulation off the wires, and that is a recipe for shorts. You need less than 1/4" to cover the pad, don't strip that much, particularly if your jacket melts back, which it looks like it did. Use flux, pretin the wire, and bloop it quickly. Looks like you're trying through-hole soldering, but if you watch madcow's videos, he goes on the pads, not through them.
Tom
Bookmarks