My Sith Saber MHS Builder version

[D'Tan]

My Sith Saber.jpg


This is just a starter. This will be my second build after I do my first one once TCSS gets the parts for my build.

Does this look like it will work?

Thanks,

Shawn

[Greenie]

It all depends on what's going inside, but with many options available it looks good for room. I have a 12mm mom switch in a 2" double F and I believe a 16mm will fit also.
Oh, and I do like that design, I look forward to seeing it built

[D'Tan]

Thanks Greenie. Yeah it has room in it. I wanted to make sure. It's close to 13".

[D'Tan]

I changed it and this is the version I am going to go with.
SaberBuilder_renderSith3e.jpg

[Greenie]

I changed it and this is the version I am going to go with.
SaberBuilder_renderSith3e.jpg

My only concern with that would be mounting a sw box on a ribbed section. It may require a bit of custom work to sit flush (no gaps in the grooves)

[darth_chasm]

I like the look of this and I like the shorter design personally. What are you planning on putting inside it?

[D'Tan]

I like the look of this and I like the shorter design personally. What are you planning on putting inside it?

Yeah me too.

[D'Tan]

My only concern with that would be mounting a sw box on a ribbed section. It may require a bit of custom work to sit flush (no gaps in the grooves)

I would think they would be able to do that. What do you think?

[Greenie]

I would think they would be able to do that. What do you think?

I pretty sure that most custom work can be done but an email to Tim would be the best way to find out.
Personally, I would go with the AV switch in your first design as I find the boxes a bit awkward for handling and twirling

[D'Tan]

thanks. What is Tim's email? PM me if you need to.