PC 3.5 beeps and then shuts down

[Rpg007]

I'm new to this but have gotten my PC 3.5 up and running with two auxillary momentary (12 mm green and a red ring) switches and tri-rebel star (RGB) running off of a 7.4v Li-ion 800mAh 14500 Battery Pack.

I used two 20mA DynaOhm? Variable Resistor for each of the momentary switches. Blue die has a 1.5 ohm 5watt; red has 2 ohm, 3watt; green has 2.2 ohm, 5 watt.

boots fine, but after varying amounts of time after either a FOC or swing, it beeps very loudly and then shuts down. I can start it right back up, and again after a short period of time (but varies) after a FOC or swing, it beeps and shuts down again.

any help is appreciated. -Rodney

[Forgetful Jedi Knight]

It sounds to me like you are trying to pull too much power from that particular batter pack (which can't handle it) and therefore the PCB trips, and your saber shuts down.

[Rpg007]

Is there a more powerful battery pack you can recommend?

[Forgetful Jedi Knight]

The only one that is a similar size in the 14650's. It all depends on how much room you have in your saber.

[Rpg007]

As this is my first saber -- I have no problem building out what I need to learn how to build the next one better.

[Rpg007]

After sleeping on this problem I decided to try the other two sound banks -- and no problem... something is up with bank 1 -- both the other two worked beautifully..

[Forgetful Jedi Knight]

After sleeping on this problem I decided to try the other two sound banks -- and no problem... something is up with bank 1 -- both the other two worked beautifully..

Go through your configurations.