Originally Posted by
obi-one
Hi everyone.
So far I've been reading and learning, I think every MHS hilt mainbody has some sort of sleeve or something where sits the heatsink until gets secured by screwing the bladeholder to the hilt. Am I right on this?
Now my question is, if I use a MHS choke, then, the heatsink now goes in the choke or remains in the main body? if it remais in the mainbody, am I not to lose some light intensity in the blade?
And also, if I am going to use a sink tube, then I guess I'm gonna have to figure out my own way to hold the heatsink, right? probably I can use some screws or something.
Sorry if this is an annoying question, or if it has been asked before too much times. I'm about to order all the stuff I think I need and just wanna make sure.
Thanks
Bookmarks