In my current saber design, I have noticed a possible mistake.

Screen Shot 2014-12-20 at 5.19.34 PM.jpg

The heatsink seems to protrude into the choke. While the MHS builder shows the heatsink to fit snug inside the choke, the shop contradicts this visualization.



I have chosen Heat Sink V3 for my saber, which has a diameter of 1.130 inches as shown in the image above. The inner diameter for the choke appears to be about 0.75 inches, based on the MHS builder.

Do I need to get a different heatsink? Flat style, "old style"?