Hey fellas, it's me again.

As you may know already, I have this purple saber project. But since I don't know much electronics (you surely know that by reading my posts), I tried to learn the stuff and ask for advice. So I was advised to use the following:

- 2 Li-Ion 18650 rechargeable cells
- a "stick-pack" (what is this?)
- 2 buckpucks (1000 mA)
- A 10W RGBA from LedEngin
- TCSS optics (copper heatsink, 8.7 deg lens, appropriate lens holder)
- A LED Driver
- A 3.3 Ohm resistor (for the red die).

The questions (if I'm not asking too much, of course):

- How to wire the driver?
- At which current do I set the driver? I'd try 700 mA because of this http://br.mouser.com/catalog/catalogUSD/642/97.pdf - it reads "Current: 700 mA"), but am I overlooking/forgetting anything?
- Even though I'm going to use the RGBA's blue and red dice, I only need one driver, right?
- How to wire the pucks (position, etc)
- In case I do not find a "stick pack" or I can't use it for whatever reason, is there any alternate way to wire the Li-Ions?

I hope I do not bother you with these questions. Thanks for your time!