Wiring the LED in an 8-pin illuminated switch?

[Mah Al Ibara]

I have an old momentary switch with a ring light, and I want to use it with a Crystal Focus 5.6 board so that the ring lights up while the saber is on, but off while in sleep mode. I assumed I would one of the accent LED pads, but I don't know what to connect where. I found an unhelpful diagram on a site that sells a similar switch, which I'll attach here along with a photo of my actual switch.IMG_9954.jpgIMG_9955.jpgLTCH-K3-ORG_3.jpg

[Strydur]

Diagram here.
16mm Anti Vandal Latching Blue Ring Switch (thecustomsabershop.com)

To keep it as basic as possible.. use C1 and NO1 for the actual switch wires.

[Forgetful Jedi Knight]

I have an old momentary switch with a ring light, and I want to use it with a Crystal Focus 5.6 board so that the ring lights up while the saber is on, but off while in sleep mode. I assumed I would one of the accent LED pads, but I don't know what to connect where. I found an unhelpful diagram on a site that sells a similar switch, which I'll attach here along with a photo of my actual switch.IMG_9954.jpgIMG_9955.jpgLTCH-K3-ORG_3.jpg

I’m not sure that the 5.6 had sleep mode, or that you’ll be able to turn off the switch light when the saber isn’t running.

[Strydur]

If it is a latching switch that will not matter.

I know the OP said momentary but it looks like a latching one to me.

[Mah Al Ibara]

If it is a latching switch that will not matter.

I know the OP said momentary but it looks like a latching one to me.

Tim, you might be right! I don't have the original packaging. I will test it.

[Mah Al Ibara]

I was sure that Tim was right and these were latching, but when I wired everything up, they wouldn't work with the default Crystal Focus setting of latching. (The saber stayed on and would only turn off for a split second before starting up again.) When I changed the settings to momentary, the switch worked fine. But though I wired up the LED to the first accent LED pad on the CF, it didn't light up. I need to check the settings on the micro SD and also make sure my bridge is actually bridged and the other wires are solid.