Hi I am truly sorry. I have no electronic experience and have never attempted anything like this. I have built a neopixel saber using a CFX. It has been interesting and taken a while but I either have it all done or understand it all. The one exception is I have built a crystal chamber and purchased the illumicore crystal from TCSS. I have scoured YouTube and these forums but I cannot for the life of me understand how to wire that in. I just want it to mirror the blade. I dont care if it is in series or parallel. I just want mirrored in the SIMPELIST and most reliable way. Yes I have looked at the diagram on page 123 of the manual and I dont get it. I really need someone to either very specifically as in (Splice pos wire from blade to pos in on illumicore. spice neg from blade to neg in on illumicore. Run data from board to data in on illumicore and from data out on illumicore to blade.) Literally tell me where each wire should start and end. a very simply diagram that looked like a board a blade and a crystal would help as well. Again I know it is a pain and I am sorry for my lack of skill here. I realize to most of you that picture in the manual is simple and clear but it is just not to me. Finally if I wire it as you direct will I need to change something in the file like number of pixels? Thanks in advance for any help. I will be away from the 1st till the 10th so if I dont respond or thank you again quickly dont think I just flaked on you.