Results 1 to 1 of 1

Thread: Pixel Blade w/ Crystal Chamber Wiring to Golden Harvest

  1. #1

    Default Pixel Blade w/ Crystal Chamber Wiring to Golden Harvest

    I'm just hoping to get some more experienced eyes on my wiring diagram before I start soldering. This is my first saber and I knew almost nothing about wiring/electronics before starting, but I've done quite a bit of research and I think I'm almost ready to put everything in place (barring any dumb issues I'm overlooking).

    Link to Wiring Diagram

    Here are my major electronic components:
    Golden Harvest v3 Phase 4
    Keeppower Li-Ion 18650 3.7V 15A 3000mAh Battery
    KR Pixel Stick V2 34.75"
    5mm RGB LED (for CC)
    Switchcraft 2.1mm Recharge Port
    16mm Anti-Vandal Momentary Switch (no LED) x1
    2W 28mm Bass Speaker

    Some questions I haven't found answers for so far:
    Is there any reason I shouldn't just use DynaOhm variable resistors for the CC LED aside from internal space issues?
    Should I be concerned about heat management for the CC LED?

    Any feedback is really appreciated
    Last edited by MrX3noverse; 05-09-2022 at 05:11 AM.


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts