Hello There,

this is my first Thread in this Forum, so if I'm doing anything wrong, just let me know

Anyways, regarding my problem. I've recently build my first Lightsaber (Obi Wans RotS Saber) and I'm nearly finished. Everything works fine. The only Problem is that the blade falls out of the Blade Holder very easily. I used two Retention Screw to hold it (you can see that on the pictures) but even when they are really tight the Blade will slip out of the holder. My guess is, that because of the LED the Blade isn't far enough inside the Blade Holder and therefore the Retention Screws doesn't work as good as they should... but I don't really get why. I bought the Blade Holder at the Custom Saber Shop. Aren't these Holders build for carrying a Led with Heatsink etc. as well as a Blade?

If anyone has an idea if that might actually be the problem or even has a solution for it, I'd be very thankful

20190827_140918.jpg20190827_140930.jpg20190827_140941.jpg