Nano Bisc. V4 activation issues

[TheMohawkNinja]

Hello,

I recently soldered up a Nano Bisc V4 to make sure everything is wired correctly. On the first power on, everything worked fine (power up sound when removing kill key, and LED+sound when activated) for a few seconds before it suddenly shut off.

Now, every time I remove the kill key and activate the saber, the LED turns on, increases in brightness for a couple of seconds, and then the speaker makes some crackling pop noise and the LED turns off. I'm guessing I may have somehow shorted something, but I don't know what.

Pics of the wiring: https://imgur.com/a/xnkXfhp

Thank you,

[Forgetful Jedi Knight]

1. Did you make sure the battery is fully charged?

2. Please show a close up of the wiring on the board.

[TheMohawkNinja]

1. Did you make sure the battery is fully charged?

Yes.

2. Please show a close up of the wiring on the board.

I did, there's an Imgur link in the OP.

[scott]

No offense, but for being outside of the hilt, those wires are a mess. I can’t tell where your activation negative is going...should be to the board negative. The symptoms seem to be activation related to me.

[TheMohawkNinja]

No offense, but for being outside of the hilt, those wires are a mess. I can’t tell where your activation negative is going...should be to the board negative. The symptoms seem to be activation related to me.

It's not supposed to be pretty, as it's just making sure that I actually know what I'm doing.

I'm not sure what you mean by activation negative. If you mean the common pin of the switch, that's going to the activation pad. Board negative is tied to both the normally open pin on the switch and the S/C pin on the recharge port.

[Jediseth]

It’s a little hard to see what’s going on, but I’d start with taking the accent pad for the power indicator off the switch including both the positive to the pad and the negative to the board. Use a standard switch. Start with basics and see how things are working maybe then start adding other things.