Hi All,
I've wired up a Warsabers Cerberus but it doesn't seem to be working. Picture of how I've wired it is attached.
37085267_10160668999295002_760123376470589440_n.jpg
I've tried a new switch, a new battery.
I initially wired it up without the tri-cree and it seemed to power on would cycle through fonts and generally behaved normally. Once I added the tri-cree everything stopped working. When I press the switch the speaker crackles with what sounds like it might be the boot sound. I press it again and the red die on the tr-cree lights up, any further presses do nothing and its now stuck in this state unless I remove the battery or plug in the USB charger.
Battery is disaplying 4.1V on multimeter and I left it charging for a few hours to be sure.
I removed the tri-cree from the board and tested each die to check my wiring, all fine, all working.
I'm at a bit of a loss and the Warsabers facebook chat haven't got back to me
help please!
Bookmarks