-
CF 8 Assistance
Hello All,
I was going to rewire my FOC3 today after breaking the connection running my recharge port wires under the board-when I noticed the connection still in tact as well as still putting out 5 volts.
So I thought maybe I had an issue with the wire somewhere else- I wired a battery to the ends of the pos and neg leads for said LED and it powered up fine(At LED Star and on board leads). But still no LED
when I power on the board. Once again I use the volt meter and read about 5 v coming from said FOC3 pad/wire and nothing getting to the LED.
I proceeded to check the main LED voltage with the volt meter, when the speaker started to make static sound- no hum ,clash anything. I powered down the saber, installed the kill key. Rebooted saber fine-But meow when
I power up the saber it automatically powers down when I release the power button. It never did this before. Not able to change colors but it will enter sound font menu.
I gotta get some pictures-though I dunno if it will help-
board easy.jpg
7.4 volt battery pack
recharge port
tri cree RBGA
2x momentary switch
2x accent led
Any suggestions on LED repair?
Or how to get the board to stop powering down on its own?
Anyone else experience this?
thanks,
Last edited by Salohcin0083; 11-08-2016 at 04:26 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks