Originally Posted by
Salohcin0083
Hi Knight,
I added some more info to the original post,
Essentially- I used a battery pack at the board ned/pos and FOC3 pad to confirm wiring/soldering -that worked to ignite LED3. I checked the sd card and it is set to use FOC3 pad. I used volt meter to confirm power from FOC3 pad. Except still no LED 3 at all.
My board also will not stay ignited. As soon as I loose pressure on the power/momentary switch the board powers down. I changed no wiring or sd card parameters when this started to happen- I was checking the voltage to Main Led from board pos and neg pads when saber started to show signs of auto power down.
I would like assistance in getting my LED3 to power on when the saber is in use.
I would also like any suggestions for the sudden powering off.
thanks,
Bookmarks