I'll heat shrink the recharge port legs-

I am able to test the Green LED with a separate 3 v battery pack. I installed the kill key-I ran the leads from the separate battery pack to the ends of the green LED wires where they connect to the CF and I am able to get the green to lite up.

I also used the volt meter on the FOC pad(same pad/wire end tested with separate pack) where the green is wired to and it does have close to 5 v coming from the pad- and still no green LED.

In my(noob) mind, I would think the above test would tell me that the wiring of the green is ok.

Imma be sure to heatsink in the morning and update-

thanks again