Nano biscotti v3 wiring harnest question

[Ely Vader]

Can anyone show me a diagram using the wire harnest with JST connectors? My set up involves an illuminated momentary switch and a recharge port.
I pretty much got it figured out from all the biscotti V2 diagrams. But it's the pre-wired orange FoC wire on the V3 that I can't figure out plugs to what...

[Silver Serpent]

Orange wire goes to FoC LED negative. Connect the FoC LED positive to the common positive on the board.

[Ely Vader]

Is it true FoC will only work with a tri-Cree LED...and if I have a different LED to just leave the orange wire alone?

[Silver Serpent]

FoC only works with a multi-die LED. Tri-Cree, Tri-Rebel, Quads, etc. It doesn't work with a single die LED.

If you only have a single die LED, you'll ignore the orange wire.

[Greenie]

Any multi die LED can be used. TCSS stock tri rebels and tri Crees. Generally, people tend to use two dies for the main blade and the third for FOC with an appropriate resistor on each.

[Ely Vader]

On the harness....the blue and white is for the main LED...is the white wire positive?

[Forgetful Jedi Knight]

On the harness....the blue and white is for the main LED...is the white wire positive?

Match the harness up tot he diagram in the manual, and that should show you everything you need to know.