Hey everyone,
I am trying to wrap my head around this setup. This is the first time I have wired a Prizm board. I want to setup an illuminated switch where the LED turns on once the saber blade comes on. I know that you can use the accent LED pads to make it blink once it has power but I would prefer for it to remain off until the blade is on. I've read through the Prizm manual and watched Rob's videos, but I can't seem to grasp an answer. Is there anyone willing to give me a hint on where I need to wire the switch LED to make it remain on during blade use? I've attached a quick drawing I did in paint as to what my wiring is so far. Thanks!

Prizm1.jpg