Did not get much response form the couple we sent out. Just sent out another so once I hear back on that one we will move forward. I think they are good to go though.
Did not get much response form the couple we sent out. Just sent out another so once I hear back on that one we will move forward. I think they are good to go though.
Tim
The Custom Saber Shop
Anyone the size and length of those headless screws on both sides of the hilt? In the 19th picture.
I'm just sitting here pissed off that the conversion kit was finally released...and it sold out day one before I was able to buy one for myself...
>_<
fml
We did a small batch to begin with as we did not get much response on the Prototypes we sent out. What we did get was positive but not enough that I was going to risk sending out 100+ bad ones. We will make more as soon as we get positive feedback or at least no negative feedback.
Tim
The Custom Saber Shop
TCSS MODERATOR
All n00bs READ these first (PLEASE)!!!:
1. Forum Guidelines
2. FJK’s “Down and Dirty” guide to Ohm’s Law
"Yeah, yeah, I've heard it all before... you want blindingly bright, super loud, running 1138 blinkies off of the cheapest sound card you can find AND you want all of it to run on a battery the size of a dime, and run for a very, VERY long time. That one cracks me up every time..."
My email: fjk_tcss@yahoo.com
What can I use to bridge the 5 pads together?
And do you reuse the cross guard blades? If so do you have to cut them down or sand them?
solder..wire..etc..
You do nothing to the side blades as this kit only addresses the main blade.
Tim
The Custom Saber Shop
Bookmarks