Here is my part list of what I am planning on ordering:
Updated:
Outter Design:
MHSV1 Blade Holder Style 19 w/ MHS Heat Sink V4 (Flat Style)
Activation box style 19
MHS deep ribbed extension
MPS Pommel style 4
4" Deep fluted
4" Double female
Double ended male threaded connector style 1
MPS Pommel style 4
Kill plug style 2
MPS Insert style 6
Inner Design:
Chassis Disc style 5 x2
MHS speaker mount V4 - For 28mm Speakers
Acrylic Chassis Disc for PC 2.0 and 18500/18650 pack - S2 (Black) x4
1/2" Aluminum 3/16" OD spacer (Black) x6
1" Aluminum 3/16" OD spacer (Black) x6
2" Aluminum 3/16" OD spacer (Clear) x6
3/4" Aluminum 3/16" OD spacer (Black) x6
Brass 4-40 Hex nut x10
Stainless 4-40 all thread x2
Switches:
Black momentary switch
Switchcraft 2.1mm Power Jack
3.5mm R.I.C.E.? Port Style 2
16mm Anti Vandal Short Momentary Red Ring Switch
Electronics:
7.4v Li-ion 1600mAh 14500 Battery Pack
Premium 28mm Speaker
Petit Crouton V3 Color Xtender
Petit Crouton V3.5
270ohm 1/4w resistor
LED:
Red/Green/Royal Blue Cree XP-E2 CopperNova
18deg Tri-Rebel/Cree Star Lens
Star thermal tape pad
Misc:
3.7V-14.8V Li-Ion Smart charger
Super Lube Synthetic Grease
USB to 3.5mm R.I.C.E.? cable
8-32 x 3/8" Stainless Steel thumb screw; blade retention screw
8-32 x 1/4" socket head
Box 19 Mounting holes service
Drill & Tap Hole (8-32) for retention screw
Drill & Tap Hole (8-32) for covertec button
Lots of wire and heatshrink
MHS Builder:
new design.jpg
So, do you all think I got everything for now?
I do have a question though. For the 16mm Anti Vandal Short Momentary Red Ring Switch, a: Will it fit within box 19 and b: do I need to wire a resistor to the lighting portion of the switch (I'm a little confused about it), or will the Petit Crouton take care of that?
Thanks!
Bookmarks