Help with CF 7.5 PWM signals please

[Zahc Zi Phan]

Hey all. Just a very simple question. I am looking for the forward voltage of the PWM signals that connect the CF 7.5 to the CEx so that I can calculate resistors and wire in a 5MM RGB for chamber/blade mirroring. I cannot find that information in the plecter manual at all.

There are three channels, one of which (main channel) is "grabbed" next to a small SMD part on the board. If someone could find that info (FV of PWM pads) for me, it would make my life so much easier.

[Forgetful Jedi Knight]

It's the same as the accent pads.

[Zahc Zi Phan]

Facepalm. So 3.3v then? Well that's simple. Thanks again FJK.