After looking over the nano biscotte manual, I decided to make a diagram detailing the wiring so that I would have a guideline when I'm actually soldering things together. Since this is my first time working with FoC and wiring multi die LED's, I'm not sure if I got everything correct.
My goal is to have a more blue-ish purple blade, as opposed to a more pink-ish purple. Additionally, the accent LED would be off when the blade is deactivated due to the kill switch.
saberWiringDiagramMINE.jpg
The parts in the diagram are:
Custom Tri-Cree LED - http://www.thecustomsabershop.com/Cu...LED-P1035.aspx
Momentary 16mm Anti Vandal Green Ring Switch - http://www.thecustomsabershop.com/16...itch-P585.aspx
Power Extender 2.0 - http://www.thecustomsabershop.com/Po...r-20-P652.aspx
Single Cell 18650 3.7V 3400mAh - http://www.thecustomsabershop.com/Pa...tery-P853.aspx
Switchcraft 2.1mm Power Jack - http://www.thecustomsabershop.com/Sw...Jack-P822.aspx
Premium 28mm Speaker - http://www.thecustomsabershop.com/Pr...eaker-P77.aspx
Any input would be much appreciated!
Bookmarks