-
PC sound problem
Hey gang,
Have had a saber with PC 3.5 working for a few months but today after unplugging from recharger, I have no sound. All LEDS and FOC is working, but no sound. Checked board and found no changes to my wiring or soldering. Voltmeter shows no power going to speaker when tested at board connections. SD card is in place properly. Don't think I could've muted it because I don't have an aux switch wired up.
I've only found one other mention of this kind of problem on the forums but there was no resolution post...
Any ideas?
-
Jedi Council Member
I would first try replacing the speaker and see if that helps. Past that, we would need to see good, high quality pictures of everything (wiring at speaker, on the board, etc). You really should have an aux switch with a PC.
TCSS MODERATOR
All n00bs READ these first (PLEASE)!!!:
1. Forum Guidelines
2. FJK’s “Down and Dirty” guide to Ohm’s Law
"Yeah, yeah, I've heard it all before... you want blindingly bright, super loud, running 1138 blinkies off of the cheapest sound card you can find AND you want all of it to run on a battery the size of a dime, and run for a very, VERY long time. That one cracks me up every time..."
My email: fjk_tcss@yahoo.com
-
Jedi Padawan
Sith Adept
Jedi Padawan
I would double check your config files on the SD card, there is a volume parameter that could have accidentally been set to 0, which would conceivably cause this issue
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks