Forgive my ignorance, as I've been trying to figure this out all night.

I have a PC3.5 (just got it today) that I am trying to wire up. I'm staring at wiring diagrams, and I thought it was all wired up good. I go to fire up the saber and nothing happens.

I'm using the MWS wired recharge port and MWS wired momentary switch.
http://www.thecustomsabershop.com/MW...ckel-P878.aspx
http://www.thecustomsabershop.com/MW...Port-P877.aspx

I have the switch wired to the ground and activation pads and the LED ring ran to the accent LED

My recharge port is connected to the power pads and to the battery pack

LED is connected to the LED pads.

Any suggestions?