I'm ignorant when it comes to resistors. I have a Nano Biscotte v2, 2W 28mm Bass Speaker, momentary switch, battery holder (2 AA), and a Red Led LEDENGIN. The issue I'm having is that when everything is hooked up and powered on, swing and clash effects keep going off randomly. I made sure the board wasn't moving or hitting something and the issue remained. I read that another Jedi (see what I did there) was having the same issue and all he needed to do was attach a resistor to solve the problem. However, he had a different setup. Upon purchasing a 1w 10ohm resistor, the sound issue was fixed BUT the light was very VERY dim. So, no good. I read on the main site that I needed a 2w 1.5ohm resistor (which is not available at Radio Shack over here). Before I order this part: Will a 2w 1.5ohm resistor solve the problem? The battery powering the whole get-up is a Tenergy 14500 800mAh 3.7v 2.96Wh. Just one. I read that the board is good for 3.7v-5.5v. So, ignorance showing again, I'm using one dummy cell and one 3.7v battery as to not over power it (cause two 3.7v batteries equals 7.4v, correct?)
Sorry for the short story and thanks for any and all help.