Hi to all
Iv been out of the hobby for a while and a bit unsure of my calculations . I am currently using a tri rebel bbw ( blues in parallel and white for foc) running from a single 18650 and NB board. This is my first multi die setup and what i'm unsure of is when i calculate the two resistors for the blues do set current at 1000ma as for a single die or 2000ma with them being in parallel?
I also wanted to ask if anyone can shed any light on to why you should not use metal film resistors as highlighted in the NB manual. The reason i ask is these seem to be the only type i can find locally with the values close to what i think i need, I am currently looking at using 0.5Ohm 1/2w on all three die's but as i said before i am unsure even after reading as much as i can find on the subject.i also want to stay away from using drive if possible as i read it can cause heat problems
any help is very welcome
Bookmarks