Help! I have this issue now with multiple sabers: the switches (AV, latching, momentary, you name it) are all quite bulky and eat up most of the place inside the hilt, even the smaller ones stick in halfway through the inside of the hilt, basically blocking the way to extend the chassis. Even with ridicolously long hilts, I face this issue. Moreover as they are screwed in place, I need to draw 2 long wires from them to be able to connect to the Chassis when it's pulled out of the hilt. The LED module is usually above it and sits just below the blade holder, i.e. again I route a bundle of wires from the LEDs bypassing the obstrusive switches to the chassis, this ends up in a mess, a jungle of wires which gets squeezed, time to time causing signals to get disconnected...
From some of you guys I see chassis in which it seems both the swicthes and the LED module are integrated. Ideally I wish a chassis which I can shift in and out, being everything there. But I would like to hear what you do to have more space in the hilt and less wiring.
Thanks a lot in advace for sharing your thuoghts!
Bookmarks