Chassis

[Sarich]

So, once I get settled in to my new apartment in a few months, I'm finally going to be buying the parts I need to make my Crystal Focus 7 saber. However, I am super paranoid about chassis parts, mainly that I am going to buy the wrong thing. My question is this; which discs do I need to buy to actually keep everything locked together. I have the PC 18650 combo discs(just a bit of modding to make a CF fit right) and the Speaker Holder 4, but which disc would I get to actually keep everything all nice and not sliding about everywhere?

[Forgetful Jedi Knight]

If you use speaker holder #5, that would solve most of your problems.

[Sarich]

I did think about that one, but I wanted to be able to have the bottom half of the saber slide off to gain access to the recharge port, and that holder prevents that.

[Forgetful Jedi Knight]

Then you would have to secure it at the other end, sounds to me like you'll need to use some metal disks. Seeing the design would be helpful.

[Sarich]

Yes, that is true, lemme pull it up:



It's a 4 inch fluted section, followed by the double male extension, then 4 inch plain section. On the double male will be a Graflex clamp, with the switches mounted on that... somehow

[Forgetful Jedi Knight]

You will likely have to put the disk between the double male and the 4" plain section, somehow.