1st Ever Stunt Saber Build.
SaberBuilder_render.jpg
MPS Pommel style 3 v1
MHS ribbed extension (Drill & Tap Hole (8-32) for covertec wheel)
3" Double female threaded connector (Machine recessed AV switch hole)
MHS choke style 1 short
Screw on LED blade holder style 16 (Drill & Tap Hole (8-32) for retention screw) with 8-32 x .3" red thumb screw
Machined button for Covertec clip with 8-32 x 1/2" button head screw
MPS Insert style 4 with MPS Clip
THE ELECTRONICS:
MHS "new style" Heat Sink V2
TrustFire Protected 3.7V 900mAh 14500 Lithium Battery (2-Pack)
Luxeon Rebel Star (Green)
BuckPuck 1000mA 4-wire
Collimator Lens 8.7 deg viewing angle with Luxeon Rebel Lens Holder
16mm Anti Vandal Short Latching Green Ring Switch
220ohm 1/4w resistor
This is the diagram I will be using.
saber wirein diaram.jpg
BLADE:
LED "TCSS style" Show blade 1" OD (36 inches)
Any suggestions?
Bookmarks