Hi there -
I'm new to the forum and this would be my first custom build. I really like the idea of using the long choke on a 12 inch saber (see the attached jpg). Given the general lack of real estate for switches, I'd really like some advice on where to put the primary and secondary momentary switches on this design.
Custom Saber Pic (long choke).jpg
My first idea was whether TCSS could machine the primary switch hole in the base of the choke -right above the threads near the middle of the saber. I'd prefer a full sized secondary switch, but I may need to settle for something smaller mounted in the mara jade extension. That is unless I can put another switch hole in the 3/4" inch extension, but that would involve drilling through the threads between adjacent sections.
Any suggestions?
Thanks in advance.
Shady Canuck
Bookmarks