ok I want a good purple blade color........ this is what I have come up with. I am told to run the blue and red in parallel, at 2000mA and resister the red. That's a lot on a first build but I as sure I can do it I just need help with the math. First is the FoC Think I have got it. This is my LED
LED Engin LZ4 10W Multi Color (RGBW) with a 7.4v Li-ion 1050mAh 14650 Battery Pack.
7.4 source voltage
3.3 diode forward voltage
1000 diode forward current (mA)
The wizard recommends a 4.7 Watt capable or greater 4.7 ohm resistor. The color code for 4.7 ohms is yellow violet gold.
What I don't get is the Parallel. So I run the neg from the PC 2.0 to the neg on the blue. Then run a wire from the pos on the blue to the pos on the red? and then a wire from the neg on the red back to the pos on the board? lol a little help please.!!!
Bookmarks