Xiohara
This is a commission I took because I wanted the challenge, which was this: "Create a saber staff that is an evolution of K3GR1 Oxidium and give it claws." Oh yeah, it is for the expressed use of Martial Arts combat. First problem was a claw design. I have a few from various projects that I have going. These are designed for an upcoming project. The 3D modelling was done by Force Relics and the two sets of claws cost ~$575. You guessed it, this is one seriously expensive project and it has no sound. The saber needed to be as close to 5'10" from tip to tip as possible. It ended up at 5' 9 1/2". I went with a Corbin V2 driver as this one's heart. Also used a 1200 mAh Li-ion pack with a red ring switch and recharge port. The faux leather-wrap grips are weathered to match the Oxidium weathering. I hope she is satisfied with it.
Particulars:
MHS-blank-based Custom machined hilt
Double-set of Quinaesnadia Claws (stainless)
Corbin V2 Driver
7.4V Li-ion (1200mAh)
Red 3W LDM LEDs
Faux Leather Wrap Grips
CT Wheel
Oxidium Weathering
Red-ring AV
The BMT:
The Glams:
Bookmarks