Quote Originally Posted by forgetful jedi knight View Post
No, with Tri-Rebels, if you went 1000 mAh per die, you would likely pop the LED. Reds need less amperage and voltage to run. 700- 750 is basically the max they can SAFELY take. What resistor did you use on these LED's?
No resistor, just driver board set to 1400mA in the config file.

I also tested the dies individually the old fashioned way, with a 3V battery pack and a 1 Ohm resistor - given the spec sheet 2.3 V this should have given them 700mA - this measured out at the rough same brightness as the driver was giving.