Hi,

I was working on my new build for quite a while. I would like to use Crystal Focus V6 and LED Engin.
This is my wiring diagram for the top side of the CF6 card and bottom for the color mixing. Also I will attach calculated resistor chart.

General wiring.jpgCOLOR MIXING CF6.jpgRESISTOR CHART.jpg Please correct me if anything is wrong. I will really appreciate that
Which resistors should I use? The ones I have selected are not shown on the website. Is it ok if I use higher value resistor?
I didn't include resistor values for the LED bargraph because I didn't find the LED's I am going to use yet.

LED mixing include R.I.C.E. port and all dice connections to the board so please let me know if these connections are right including the resistors. My main question I was mostly concerned about is if I need resistor for the main die (GREEN connected in series) because it is only 1ohm according to the calculations. However, I thought there is a current reducer attached to the board. Is this correct? Or do I have to attach this 1ohm resistor?

I am also going to build other saber which I have already designed but I want to use Luxeon Tri-Rebel Star Rb, Rb, W. However, I couldn't find forward voltage for it, so I couldn't find the right resistors.
This second saber is going to be similar in electronics build but it will not be including the color mixing feature.

This is pretty much it. I will appreciate all helpful comments. Thank you!